R-SE9T/ DP-SE9/ X-SE9 (En)
28
Preparation sectionBasic sectionApplication sectionKnow ledge sections
Recording
1. Load a tape in deck.
2. Select the tape transport direction.
3. Set the recording condition.
1 Open the tray of the cassette deck.
2 Insert a tape.
3 Close the tray.
Recording
Recording
÷ When recording is started, the tape is transported in the
direction selected in this step.
÷ Wind the tape to the position where recording is to be
started.
÷ Differentiation between normal (TYPE I) and high
(TYPE II) tape is set automatically.
÷ Remove tape slack before loading.
1 Press the playback key for the direction to be played (lights green).
2 Stop playback (lights red).
1 Select the reverse mode. £
2 Select the DOLBY NR mode. £
Check the tape transport direction
indicator.
Note that this cassette deck cannot record onto Metal
tapes.
Note
Note
Top side
Reverse
side
To reverse the transport direction
33
55
44
22
33
11
0
11
32
rev. mode
33
Dolby NR
33
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
