48 TFCB-A_TFCB-B-BA-def-2313
13.2.2 Checkweighing
With the <Checkweighing> application variant you can check if the weighing good is
within a predefined tolerance range.
When limit values are exceeded below or above, an acoustic signal (if enabled in
menu) will sound and an optic signal (tolerance marks) will be displayed
Optic signal:
The tolerance marks provide the following information:
Weighed-in goods exceed predefined tolerance
Weighed-in goods within predefined tolerance
Weighed-in goods below predefined tolerance
Acoustic signal:
The acoustic signal depends on the menu setting
< setup > < beeper >, see chap. 14.3.1.
Procedure:
1. Define limit values
Using the navigation keys select the setting
Select < limits> and confirm on ➔ button.
< limupp > will appear.
Press ➔ button to confirm, the numeric input window for
entering the upper limit value will appear.
The active digit is flashing.
Enter upper limit value (numerical input see chap. 3.2.2)
and confirm the entry.
The balance returns to the < limupp > menu.
To Next Page
Loading...
Need help?
General
