7.5 Parts counting
You are weighing e.g. 10 identical parts; i.e. the reference quantity is 10. The balance
will automatically calculate the average weight per part. From now the pieces to be
counted are displayed as number of parts. As a rule:
The higher the reference quantity the higher the counting accuracy.
Explanations for the balance settings:
The reference formation needs an exact determination of the weight value. The
settings „Con 1 – 5“ (see chapter 8.2) influence this reference formation.
When using the counting function we recommend the setting: „Con 5“.
Operation: Display:
Ö Turn on balance using the ON/OFF-button
0,000
Ö Press Tare-button
-- -- -- --
Ö While this display is on, press the F-button until PIECES
is displayed
PIECES
Ö Press PRINT-button and reference quantity appears. By
pressing the F-button, you can select 10, 20, 50 or FrEE
(by choice).
10
pcs
Ö Confirm entered reference quantity by pressing the
PRINT-button. If you wish to select reference quantity by
choice, proceed to the next step.
LoAD
Ö Enter reference quantity by choice
Use the ON/OFF-button to select the value you want to
modify, use the F-button to increase the number
(the respective active value is blinking)
Confirm entered reference quantity by pressing the
PRINT-button
00000
pcs
00017
pcs
LoAD
Ö Place as many parts on the weighing plate as required by
the set reference quantity, confirm by pressing the PRINT-
button
Proces
10
pcs
PLS/PLJ/ALS/ALJ-BA-e-0819
58
To Next Page
Loading...
Need help?
General
