Keyence DL-EP1 User Manual

- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (GT2) -
3-2 DL-EP1 EtherNet/IP Communication Function
3-4
3
Communicating with the GT2 Series
sensor amplifier's output signals and comparator values and error status without
ladder programs.
Configurations such as RPI and data size for cyclic communication are set
on the scanner side.
In a network which has many connected devices, including EtherNet/IP
devices, a delay or packet loss could occur if a large load is constantly or
temporarily applied on the network. Verify the settings carefully before
operation.
 Message communication
Message communication can be used for applications which do not require a
punctuality like cyclic communication.
In message communication, various parameters, including data which can be
exchanged with cyclic communication, can be read and written. Functions specific
to sensors such as the sensor amplifier preset function can also be executed.
PLC
EtherNet/IP scanner
RPI=3 (ms)*
RPI=0.5 (ms)*
RPI=5 (ms)*
RPI=10 (ms)*
Various EtherNet/IP adaptors
Ethernet
* RPI (Requested Packet Interval) can be set
individually for each connection.
Point

Keyence DL-EP1 Specifications

General

Brand	Keyence
Model	DL-EP1
Category	Control Unit
Language	English