Keyence DL-EP1 User Manual

5-5
5
Appendix
- EtherNet/IP Compatible Network Unit DL-EP1 User’s Manual (GT2) -
5-3 Default Settings
The DL-EP1 can be reset and initialized to the default settings by holding down the
reset switch ( Page 1-5) for three seconds or longer or by using the Identity Object
Reset service ( Page 5-21) for message communication.
The DL-EP1 default settings are as follows:
* Only the BOOTP client function can be used when the IP address is 0.0.0.0. The
IP address must be set to use any other functions.
Setting Item Value after Initialization
Communication speed 10/100 Mbps automatic
IP address setting method BOOTP
IP address
0.0.0.0
*
Netmask 255.255.255.0
Default gateway 0.0.0.0
Sensor status mask setting
MS LED flashes in red when a sensor error or warning
occurs.
Multicast TTL 1
Multicast assignment method 0 (Automatic)
Number of multicast addresses 32
Multicast address 239.255.0.0

Keyence DL-EP1 Specifications

General

Brand	Keyence
Model	DL-EP1
Category	Control Unit
Language	English