Settings Available Key
Settings
Description
Trigger Source Key, IO, or Rmt Sets the trigger source for the system.
Default is Key.
Action required:
Press Trig Src to toggle between Key, IO, and Rmt.
Key (List Run/Stop Key) Selects the Run Stopped softkey as a trigger
source.
IO (DIO Trigger In) Selects any configured digital IO (with Trigger
Input function) as a trigger source
Rmt (Remote Command) Selects a remote interface command as a trigger
source.
Trigger Delay 0 to 0.255 s Sets the trigger delay in seconds.
Default is 0 s.
Repeat Count 1 to 9999 Sets the list repeat count. This sets the number of times that a list is executed before it
completes.
Default is 1.
Continuous - Enables check box to repeat the list continuously.
Step 3 – Run the input sequence list
When Sequencer LIST is initiated, all the List properties cannot be configured, which includes adding or
removing step from the list.
When Step mode transient system is initiated, properties such as voltage mode, current mode, resistance
mode, power mode, trigger source, and trigger delay cannot be configured.
If both Voltage and Current Mode is set to Fix and Trigger Source is set to Key, pressing
Run
will automatically
set both voltage and current mode to List and start the list operation.
In this example, the load operation is in CC mode.
– Set Current Mode to List: Press Curr Mode Lst.
– Set Trigger Source to Key. Press Trig Src Key.
– Press the color-coded [On] key to enable the selected input.
– Press Run to start the list operation. To abort the operation, press Stop.
– Press Back to exit and return to the previous menu.
Keysight EL30000 Series User's Guide 91
To Next Page
Loading...
Need help?
General
