Keysight CXG, EXG, and MXG X-Series Signal Generators Service Guide 47
Boot Up and Initialization
Potential Problems During Boot Process
9. In the Command field on the Interactive IO window type
:SYST:COMM:LAN:IP? and press Send & Read to retrieve the instrument’s
IP address.
Is the IP address that is returned valid for your local area network?
a. If yes, proceed to step 10.
b. If not, the instrument may not be set to automatically obtain an IP
address. To correct this:
i. Type :SYST:COMM:LAN:CONF AUTO into the Command field and
press Send Command to switch it to automatically obtain an
IP address.
ii. Type :SYST:COMM:LAN:REST into the Command field and press
Send Command to let the instrument automatically retrieve
an IP from the server that will work on your network.
iii. Allow the instrument one minute to obtain an IP address.
iv. Type :SYST:COMM:LAN:IP? into the Command field and press
Send & Read to retrieve the instrument’s IP address.
10.Copy the instrument IP address from the Interactive IO window into the
address field in a web browser and press Enter. The browser will go to the
instrument internal web page as shown in Figure 2-7.
To Next Page
Loading...
Need help?
General
