2 Operating Information
52 Keysight 3458A Assembly-Level Repair Manual
The present AC voltage measurement method (SETACV RNDM) is displayed. At
this point, reset the multimeter to return it to the power-on state by pressing:
Digits displayed
When the multimeter is displaying readings, you can vary the number of digits it
displays. In the power-on state, the display is showing 7.5 digits although the
multimeter is resolving 8.5 digits. To display all 8.5 digits.
Press:
The NDlG command only masks digits from the display. It does not affect readings
sent to reading memory or transferred over the GPIB bus. Also, you cannot view
more digits than are being resolved by the multimeter.
The display’s leftmost digit (referred to as a 1/2 digit) is implied when you are
specifying display digits.
To Next Page
Loading...
