3 Disassembly/Assembly Procedures and Parts List
98 Keysight 3458A Assembly-Level Repair Manual
Figure 3-20 Remove/Install display screw
Installation procedure
1 Align the slots in the Display assembly with the hook tabs on the Front Panel
assembly. Be sure the board is as close to the left side of the Front Panel
assembly as possible. Then push the board down until it locks in place.
2 Push the board as far as possible toward the right side of the Front Panel
assembly.
3 Refer to Figure 3-20. Use the #TX10 Torx driver to install the screw on the
Display assembly.
4 Set the 3458A on your workbench with the right side facing you.
5 Carefully place the front terminals into the appropriate holes in the front panel.
6 Refer to Figure 3-19. Use the #TX10 Torx driver to install the two Torx screws
on the front terminals. Then use a #1 Pozidriv screwdriver to install the two
Pozidriv screws on the front terminals.
7 Set the 3458A on your workbench with the front facing you.
8 Place the Front Panel assembly in front of the chassis. Place the cable from the
display below the power transformer.
To Next Page
Loading...
