3 Disassembly/Assembly Procedures and Parts List
68 Keysight 3458A Assembly-Level Repair Manual
Covers installation procedure
Do the following:
1 Remove all connections to the 3458A.
2 If installing the top shield is not required, continue with step 6.
3 Refer to Figure 3-6. Turn the instrument over so its bottom sits on your
workbench.
4 Line up the slots on the top shield with the shield retainers. Then push the
shield toward the front of the instrument until the shield screw hole lines up
with the hole in the chassis. Use the #TX10 Torx driver to reinstall the shield
screw.
5 If installing the bottom shield is not required, continue with step 9.
6 Refer to Figure 3-5. Turn the instrument over so its top sits on your workbench.
To Next Page
Loading...
