Site Preparation Process 1
Site Preparation 1-3
Responsibilities
Successful system preparation and installation requires planning and effort by both
you and Keysight. Following are summaries of each party’s responsibilities.
• Keysight’s Responsibilities
• Customer’s Responsibilities
Keysight’s Responsibilities
As a part of the purchase of a Keysight board test system, Keysight will provide the
following:
• Site Preparation Suggestion — To help you begin, a Keysight authorized
representative will visit you to help you understand what you will need to do to
make your site ready for your system and answer any questions you may have.
This is called the “Initial Site Preparation Visit” and the Keysight representative
will bill up to 2 hours to Keysight Technologies.
• Electrical and Environmental Inspection — After primary power has been
installed at the site, a Keysight representative will inspect the lines to verify that
your electrical power is suitable for the system. At the same time, the Keysight
representative will inspect the site to verify that its environmental
characteristics conform to the site preparation specifications. The
representative will also answer any questions you may have. This is called the
“Verifying Site Preparation Visit” and the Keysight representative will bill up to
2hours to Keysight.
• Installation — After all components of the system have been moved to the site,
compressed air and vacuum have been installed, and primary power has been
run to the system location, a Keysight representative will complete the system
installation. The Keysight representative will plug in the pre-installed power
cord after testing the power.
Installation includes removing the system from the pallet, unpacking the
smaller boxes, connecting cabling, starting the system, customizing the system
software, and performing a complete system verification. The representative
will also answer any questions you may have. This is called the “Installation
Visit” and the Keysight representative will bill up to 4 hours to Keysight.
• Warranty — The Keysight board test systems include a one-year warranty that
provides on-site hardware repair, software support and software updates.
• Insurance — The system is insured by Keysight until it is delivered to your
loading dock.
To Next Page
Loading...
Need help?
General
