1Getting Started
Preparing the Power Supply
14 E3632A User’s Guide
Power-line voltage selection
Power- line voltage selection is accomplished by adjusting two
components — power- line voltage selector and power- line
fuse on the power-line module of the rear panel. To change
the power- line voltage, proceed as follows:
1 Remove the power cord.
Remove the fuse- holder assembly with a flat- blade
screwdriver from the rear panel.
2 Install the correct line fuse.
Remove the power- line voltage selector from the
power- line module.
100 Vac or 115 Vac, 4 AT fuse
230 Vac, 2.5 AT fuse
Power-line voltage selector
To Next Page
Loading...
