EasyManuals Logo

Keysight E3632A User Manual

Keysight E3632A
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Getting Started 1
Preparing the Power Supply
E3632A User’s Guide 9
Preparing the Power Supply
Preliminary checkout
1 Verify the power- line voltage setting on the rear panel.
The power- line voltage is set to the proper value for your
country when the power supply is shipped from the
factory. Change the voltage setting if it is not correct. The
settings are 100 Vac, 115 Vac, or 230 Vac.
2 Verify that the correct power- line fuse is installed.
The correct fuse is installed for your country when the
power supply is shipped from the factory. For 100 Vac or
115 Vac operation, you must use a 4 AT fuse. For 230 Vac
operation, you must use a 2.5 AT fuse.
3 Connect the power- line cord and turn on your power
supply.
The front- panel display will light up and a power- on
self- test occurs automatically when you turn on the power
supply.
NOTE
Refer to “Power-line voltage selection” on page 14 if you need to
change the power-line voltage or the power-line fuse.
To replace the 4 AT fuse, order Keysight part number 2110-0996.
To replace the 2.5 AT fuse, order Keysight part number 2110-0999.

Table of Contents

Other manuals for Keysight E3632A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight E3632A and is the answer not in the manual?

Keysight E3632A Specifications

General IconGeneral
BrandKeysight
ModelE3632A
CategoryPower Supply
LanguageEnglish

Related product manuals