81000HI - E-2000 Connector interface
For physical contact connections
Recommended for angled and straight connector
interfaces. Use with sources. Not for sensors.
81000LI - LC/F3000 Connector interface
For physical contact connections
Recommended for angled and straight connector
interfaces. Use with sources.A
81000FI - FC/PC Connector interface
N-keying (key slot = 2.20 mm nominal)
For physical and non-physical contact
connections
Recommended for angled and straight connector
interfaces
81000MI - MU Connector interface
For physical contact connections
Recommended for angled and straight connector
interfaces. Use with sources.
81000KI - SC Connector interface
For physical and non-physical contact
connections
Recommended for angled and straight connector
interfaces
81000SI - DIN 4108/47256 Connector interface
For physical and non-physical contact
connections
Recommended for angled and straight connector
interfaces
81000BR - HMS-10 Reference reflector
–
Return loss = 0.18 dB ± 0.1 dB (96% ± 2%)
typ.
– Wavelength range: 1200 to 1600 nm
A gold-plated HMS-10 connector for use in measuring return
loss of optical connectors. It allows you to establish a precise
reference for reflection measurements. Return loss is 0.18 dB
± 0.1 dB (96% ± 2%)
81000PI - E-2000 Connector interface
For non-physical contact connections
Recommended for angled and straight connector
interfaces. Use with sensors.
81002LI - LC/F3000 Connector interface
For non-physical contact connections
Recommended for angled and straight connector
interfaces. Use with sensors.
81000NI - FC/APC Connector interface
R-keying (key slot = 2.00 mm nominal)
For physical and non-physical contact
connections
Recommended for angled and straight connector
interfaces
81002MI - MU Connector interface
For non-physical contact connections
Recommended for angled and straight connector
interfaces. Use with sensors.
81000VI - ST Connector interface
For physical and non-physical contact
connections
Recommended for angled and straight connector
interfaces
81000UM - Universal feedthrough adapter
To adapt 81000BR or HMS-10 connectors to
any other appropriate connector. In combination
with a Keysight 81000xI connector interface, this
adapter allows you to mate an HMS-10 connector to another
HMS-10, FC/PC/SPC, APC, DIN, ST, E-2000, or SC connector. It
can also be used to mate a Keysight 81000BR reference reflector
to a connector under test. The Keysight 81000UM is a through
adapter only. It can not be used at the fiber interfaces of the
modules.
To Next Page
Loading...
