486 Keysight N9010B EXA Signal Analyzer Service Guide
Assembly Replacement Procedures
RF Area (Option 532, 544)
2. Refer to Figure 15-40. Unplug the ribbon cable from the A15 Front End
Control assembly.
Figure 15-40 Remove SW4
3. Remove the two screws (1) that attach the bracket to the chassis. The
bracket/switch (2) can now be removed.
4. Refer to Figure 15-41. Remove the three screws (1) to separate the
switch from the bracket assembly.
Figure 15-41 Switch / Bracket Separation
To Next Page
Loading...
