507
Assembly Replacement Procedures
Disk Drive
10.Install the Programmed Hard Disk Drive to the Top Shield using precoated
four Machine Screws (0515-5074) as shown in Figure 14-58. Torque
screws to 9 inch-pounds.
Figure 14-58 Top Shield/Hard Drive Assembly
11.Connect the Hard Drive ribbon cable from the Top Shield/Hard
Drive/Ribbon Cable assembly to the CPU assembly. When the ribbon
cable is fully seated the two locking tabs will grip the sides of the ribbon
cable connector.
12.Install the Top Shield/Hard Drive/Ribbon Cable assembly to the CPU
assembly using fifteen precoated Machine Screws (0515-5074). Torque
screws to 9 inch-pounds.
13.Refer to Figure 14-54. Replace the CPU assembly in the instrument with 6
screws. Torque to 9 inch-pounds.
To Next Page
Loading...
