508
Assembly Replacement Procedures
Disk Drive
14.Locate the Windows Vista License Sticker that came with the replacement
hard drive and apply the sticker to the rear of the instrument as shown in
Figure 14-59, covering the existing sticker if present.
Figure 14-59 Windows License Sticker Rear Panel Location
NOTE While the replacement disk drive has the Windows XP operating system
loaded onto it, the license that accompanies it in this kit is for Windows Vista.
This is being done within the scope of our license agreement with Microsoft
and is necessary at this time, as the instrument applications software is not
supported or qualified with any operating system other than Windows XP.
15.Refer to Chapter 15, “Post-Repair Procedures.” and perform all of the
specified tasks for replacing the A5 Disk Drive assembly.
To Next Page
Loading...
