551
Assembly Replacement Procedures
Front Frame Assembly
3. Refer to Figure 14-90. Disconnect the cable (1) and backlight wires (2)
from the inverter board. Remove the two screws (3) that secure the
inverter board (4) and bottom shield (5) to the display assembly.
Carefully remove the inverter board.
Figure 14-90 Inverter Board and Bottom Shield Removal
Replacement
1. Refer to Figure 14-90. To replace the inverter board (4), place it in the
bottom shield (5) on the display bracket. Line up the holes in the shield
base and PC assembly with front frame assembly. Replace the two screws
(3). Torque to 9 inch pounds.
2. Reconnect the cable (1) and backlight wires (2) to the inverter board.
3. Fit grommets inside the wire access slots if they were dislodged.
4. Refer to Figure 14-89. Align the top inverter shield (1) with holes in
bottom as shown.
To Next Page
Loading...
