Command Reference
SENSe Subsystem
122
SENSe Subsystem
Sets the instrument state parameters so that you can measure the
input signal. SENSe subsystem commands used for measurements
in the MEAS menus. These commands may be used only to set
parameters of a specific measurement when the measurement is
active.
[:SENSe]:ACPower Subsection
Set the ACP Average
[:SENSe]:ACPower:AVERage:COUNt <integer>
[:SENSe]:ACPower:AVERage:COUNt?
[:SENSe]:ACPower:AVERage:[:STATe] OFF|ON|0|1
[:SENSe]:ACPower:AVERage:[:STATe]?
To specify the number of measurement averages used when
calculating the measurement result set Avg Number to ON. The
average will be displayed at the end of each sweep. Setting Avg
Number to OFF disables measurement averaging.
*RST: 10/Off
Range: 1 to 1000
Example: ACP:AVER:COUN 10 sets 10 number ACP average.
Key access:
> ACP > Avg Number On Off
To Next Page
Loading...
