Keysight N9320B - [:Sense]:Average Subsection

143
Command Reference
SENSe Subsystem
Set the Meas Type
[:SENSE]:SEMask:TYPE TPRef|PSDRef
[:SENSE]:SEMask:TYPE?
Displays a menu where you can select a measurement reference
type, Total Pwr Ref or PSD Ref.
*RST: Total Pwr Ref
Example: SEM:TYPE TPRef or SEM:TYPE PSDRef
Key access:
> More> Spectrum Emission Mask > Meas Type
[:SENSe]:AVERage Subsection
Set the Average Count
[:SENSe]:AVERage:COUNt <integer>
[:SENSe]:AVERage:COUNt?
Specifies the number of measurements that are combined.
*RST: 1
Range: 1 to 1000
Key access: > Average On Off
Turn Averaging On/Off
[:SENSe]:AVERage[:STATe] OFF|ON|0|1
[:SENSe]:AVERage[:STATe]?
This command toggles averaging off and on. Averaging combines
the value of successive measurements to average out
measurement variations.
*RST: Off
Remarks: This command is turned off for video averaging
(
[:SENSe]:AVERage:TYPE VIDeo) When a measurement under
key is started. If this command is turned on for video
averaging when any of the key measurements are in
progress, that measurement will be stopped.
Key access: > Average On Off
Meas
BW/
Avg
Meas
Meas
BW/
Avg