Keysight N9320B - [:Sense]:Demod Subsection

Command Reference
SENSe Subsystem
130
hardware to 50 ohm. This affects the results when the y axis unit is
voltage or current units (dBmV, dBmV, V, A) but not when it is
power units (dBm, W).
*RST: 50
Key access: > More > Impendance
[:SENSe]:DEMod Subsection
Ser Demod
[:SENSe]:DEMod:STATe OFF|ON|0|1
[:SENSe]:DEMod:STATe?
[:SENSe]:Demod:AM|FM
[:SENSe]:DEMod?
To turn on/off the demodulation function at marker. Use :Demod:FM
to swicth the demod type from AM to FM.
*RST: AM/Off
Key access:
> More > Demod
Demod Time
[:SENSe]:DEMod:TIME <VALUE>
[:SENSe]:DEMod?
To set the demodulation time.
*RST: 500 ms
Key access:
> More > Demod
Demod Time
:DEMOd:MARKer[1]|2|3|...|12:STATe ON|OFF|1|0
:DEMOd:MARKer[1]|2|3|...|12:STATe?
To assign the marker for the demodulation.
*RST: off
Key access:
> More > Demod
Amplitud
Marker
Marker
Marker