Keysight N9320B - Status:operation Ragister

Status Registers
Status Register System
34
The standard event status enable register presets to zeros (0).
Figure 3 Standard Event Status Event Enable Register
STATus:OPERation Ragister
The STATus:OPERation register is used to determine the specific
event that sets bit 7 in the status byte register. This register also
monitors the current measurement state and checks to see if the
analyzer is performing measuring function:
The STATus:OPERation condition register contains the following
bits:
Bit Description
0Reserved:
This bit is not used by the analyzer, but is for future use with other
Keysight products.
1Reserved: This bit is not used by the analyzer, but is for future use with other
Keysight products.
2Reserved: This bit is not used by the analyzer, but is for future use with other
Keysight products.
3
Reserved: This bit is not used by the analyzer, but is for future use with other
Keysight products.
4
Measuring: A 1 in this bit position indicates that a measurement is in progress.