155
Command Reference
SOURce Subsystem
Set the Source Sweep Power Range
:SOURce:POWer:SWEep <rel_ampl>
:SOURce:POWer:SWEep?
Specifies the range of power levels through which the source
output will sweep. Use
:SOURce:POWer:STARt to set the power level
at the start of the power sweep. See also
:SOURce:POWer:SPAN.
*RST: 0 dB
Range: 0 dB to 20 dB
Key access:
> Tracking Generator > More > Power Sweep On Off
Output Power Tracking
:SOURce:POWer:TRCKing <integer>
:SOURce:POWer:TRCKing?
Adjusts the tracking of the source output with the spectrum
analyzer sweep in the present resolution bandwidth.
*RST: This command is persistent. The term persistent means that the
command retains the setting previously selected, even through a
power cycle.
Range: Integer, 0 to 4095
Key access:
> Tracking Generator > More > Man Track Adj
Output Power Tracking Peak
:SOURce:POWer:TRCKing:PEAK
Automatically adjusts the tracking of the source output with the
spectrum analyzer sweep so that the power is maximized for the
present resolution bandwidth.
Remarks: This command is not applicable for the 1.5 GHz tracking generator.
Key access:
> Tracking Generator > More > Tracking Peak
To Next Page
Loading...
