U9361C/F/G/M RCal Measurement Guide 71
Making Measurements
Using RCal Directly from the 89600 VSA
17. Disconnect the cable from the RCal module and connect it to the signal
generator.
18. Select Meas Setup > Source tab > RF Output On.
19. Select Marker > Marker Table On.
20. Select Marker 1 and set Marker Mode to Normal and Marker Frequency to
2.5 GHz. Repeat this for Marker 2 through 7 for 5 GHz, 8 GHz, 11 GHz,
14 GHz, 17 GHz, and 20 GHz.
To Next Page
Loading...