99
6
6
Driving your vehicle Smart Cruise Control (SCC)
僅 If there is a vehicle in front of you, the
speed may be adjusted to maintain
the distance to the vehicle ahead. If
the vehicle ahead accelerates, your
vehicle will travel at a steady cruising
speed after accelerating to the set
speed.
If your vehicle speed is between 0~30
km/h (0~20 mph) when you press the
Driving Assist ( ) button, the set speed
will be set to 30 km/h (20 mph).
To set vehicle distance
Each time the button is pressed, the
vehicle distance changes as follows:
僅 If you drive at 90 km/h (56 mph), the
distance is maintained as follows:
- Distance 4 - approximately 52.5 m
(172 ft.)
- Distance 3 - approximately 40 m
(130 ft.)
- Distance 2 - approximately 32.5 m
(106 ft.)
- Distance 1 - approximately 25 m (82
ft.)
僅 The distance is set to the last set dis
-
tance when the vehicle is restarted, or
when Smart Cruise Control was tem
-
porarily canceled.
To increase set speed
Push the + switch up and release it
immediately. The set speed will increase
by 1 km/h (1 mph) each time the switch
is operated in this manner.
僅 Push the + switch up and hold it. The
set speed will increase by 10 km/h (5
mph) each time the switch is operated
in this manner.
僅 You can set the speed to 200 km/h
(120 mph).
Check the driving condition before using
the + switch. Driving speed may sharply
increase when you push up and hold the
+ switch.
To decrease set speed
Push the - switch down and release it
immediately. The set speed will decrease
by 1 km/h (1 mph) each time the switch
is operated in this manner.
僅 Push the - switch down and hold it.
The set speed will decrease by 10 km/
To Next Page
Loading...
