ENGINE AND TRANSAXLE ASSEMBLY EMA -19
7. Disconnect the PCM connectors(A).
A
SBLM16009L
8. Remove the battery tray while recovering refrigerant.
9. Disconnect the high and low pressure pipes from the
radiator or the compressor.(Refer to Air conditioning
system in HA Group).
10. Remove the radiator.(Refer to Radiator in this G roup).
11. Disconnect the engine wiring har ness connectors.
1) Disconnect the oil control valve(OCV) harness
connector(A) and the knock sensor(LH) harness
connector(B)
A
B
SBLM16010L
2) Disconnect the MAP(A), ETC(B), ignition coil har-
ness connector(C) and the injection harness con-
nector(D).
B
D
C
A
SBLM16011L
3) Disconnect the batter y connector(A), the power
steering switch connector(B) and the knock sen-
sor(RH) harness connector(C).
C
B
A
SBLM16012L
4) Disconne ct the oxygen sensors(A), CMP(B),
CKP(C), VIV(D) and the condensor harness
connector(E).
A
A
B
CE
D
SBLM16013L
To Next Page
Loading...