EMA - 20 ENGINE MECHANICAL SYSTEM
5) Disconnector the water temperature sen-
sor(WTS) harness connector(A), the oil temper-
ature sensor(OTS) harness connector(B) and
the purge cont ro l s ole n oid valve(PCSV) harness
connector(C).
C
A
B
SBLM16014L
12. Disconnect the transaxle wire harness connector and
remove the transaxle assembly.(Refer to Transaxle
system in AT Group).
13. Disconnect the fuel hose tube(A).
A
SBLM16015L
14. Disconnect the front exhaust muffler with the exhaust
manifolds.
15. Remove the front wheels and tires.(Refer to Suspen-
sion system in SS Group).
16. Remove heater hose(A) and d isconnect the brake
vaccume hose(B).
A
B
SBLM16017L
17. Remove the exhaust and intake manifold covers.(Re-
fer to Intake and exhaust system in this Group).
18. Remove the power steering pump assembly.(Refer to
Power steering pump in ST Group).
19. Remove the hood assembly.(Refer to Hood in BD
Group).
20. Install a jack for supporting the engine assembly.
21. Remove the engine mounting brackets(A).
A
SBLM16018L
22. Jack up the engine assembly in order to remove the
engine from the vehicle.
To Next Page
Loading...