TIMING SYSTEM EMA -27
b. Check that t he mark(A) of the camshaft timing
sprockets are in straight line on the cylinder head
surface as shown in the illustration.
If not, turn the crankshaft one revolution (360
).
A
KDRF113A
NOTE
Do not rotate engine counterclockwise.
8. Remove the lower oil pan(A).
Insert the blade of SST(09215-3C000) between the
upper oil pan and lower oil pan, and cut off applied
sealer and removed lower oil pan.
09215 - 3C000
A
SBLM16019L
CAUTION
• Insert the SST between the oil pan and the
ladder fram e by tappin g it with a plastic ham-
mer in the direction of ① arrow.
• After tapping the SST with a plastic hammer
along the direction of ② arrow around more
than 2/3 edge of the oil pan, remove it from
the ladder frame.
• Do not turn over the SST abruptly without tap-
ping. It can result in damage of the SST.
9. Remove the crankshaft damper pulley(A).
A
KDRF109A
10. Remove the timing chain cover(A).
A
KDRF115A
NOTE
• Be careful not to damage the contact surfaces
of cylinder block, cylinder head and timing chain
cover.
• Mark on the timing chain on the basis of the mar k-
ingonsprocketandCVVT.
To Next Page
Loading...