EMA - 36 ENGINE MECHANICAL SYSTEM
CAUTION
• Make clean the sealing face before assem-
bling two parts.
• Remove harmful foreign matters on the seal-
ing face before applying sealant.
• When applying sealant gasket, sealant must
not be protruded into the inside of oil pan.
• To prevent leakage of oil, apply sealant gas-
ket ot the inner threads of the bolt holes.
e. Install oil pan(A).
Uniformly tighten the bolts in several passes.
Tightening torque
9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
A
SBLM16102L
24. Using SST(09231-3C300) install crankshaft damper
pulley(A).
Tig
htening torque
284
.2 ~ 303.8Nm(29.0 ~ 31.0kgf.m, 209.76
~22
4.22lb-ft)
A
KDRF109A
09231-3C300
ECRF061A
25. Install cylinder head cover.
a. The hardening sealant located on the upper area
between timing c hain cover and cylinder head
should be remove d before assembling cylin der
head cover.
b. After applying sealant(TB1217H), it should
be assembled within 5 minutes.Bead width :
2.5mm(0.1in.)
KDRF231A
c. The firing and/or blow out test should not be per-
for m ed within 30 minutes after the cylinder head
cover was assembled.
To Next Page
Loading...