Kia G6DB-3.3 - Page 35

TIMING SYSTEM EMA -35
d. Install the new gasket(A) to the timing chain
cover.
A
KDRF220A
e. The dowel pins on the cylinder block and holes
onthetimingchaincovershouldbeusedasa
reference in order to assemble the timing chain
cover to be in exact position.
Tightening torque
B(17): 18.62 ~ 21.56Nm(1.9 ~ 2.2kgf.m,
13.74 ~ 15.91lb-ft)
C(4): 9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
D(1): 58.80 ~ 68.80Nm(6.0 ~ 7.0kgf.m,
43.40 ~ 50.63lb-ft)
E(1): 58.80 ~ 68.80Nm(6.0 ~ 7.0kgf.m,
43.40 ~ 50.63lb-ft)
F(2): 24.50 ~ 26. 46 Nm(2.5 ~ 2.7kgf.m,
18.08 ~ 19.53lb-ft)
G(4): 21.56 ~ 23.52Nm(2.2 ~ 2.4kgf.m,
15.91 ~ 17.36lb-ft)
H(1): 9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
I(1): 9.80 ~ 11.76Nm(1.0 ~ 1. 2kgf.m, 7.23 ~ 8. 68lb-ft)
J(1): 9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
K(4): 9.80 ~ 11.76Nm(1.0 ~ 1.2kgf.m, 7.23 ~ 8.68lb-ft)
L(1): 21.56 ~ 26.46Nm(2.2 ~ 2.7kgf.m, 15.91
~ 19.53lb -ft) - New b olt
D
E
F
G
G
B
B
F
I
C
C
C
J
G
G
L
K
K
K
K
H
B
B
B
B
B
B
B
B
B
C
B
B
B
B
B
B
A
ECBF033A
f. The firing and/or blow out test should not be per-
formed within 30 m inutes after th e timing chain
cover was assembled.
22. Using SST(09231-3C100), install timing chain cover
oil seal.
09231-3C100
ECRF050A
23. Install lower oil pan .
a. Using a gasket scraper, remove all the old pack-
ing material from the gasket surfaces.
b. Before assebling the oil pan, the liquid sealant
TB1217H should be applied on oil pan.
The part must be assembled within 5 minutes
after the sealant was applied.
Bead width : 2.5mm(0.1in.).
A
S
BLM16020L
www.CarGarage.ir
www.CarGarage.ir
www.CarGarage.ir