EMA - 96 ENGINE MECHANICAL SYSTEM
8) Disconnect the injector wiring(H) and ignition coil
wiring(I).
D
B
A
E
C
F
SBLM16006L
H
G
I
SBLM16206L
6. Disco nnect the fuel hose tu be(A).
A
SBLM16015L
7. Remove heater hose(A) and disconnect the brake
vaccume hose(B).
A
B
SBLM16017L
8. Disconnect the surge tank stay.
9. Remove the surge tank.
10. Disconnect the injector connectors.
11. Disconnect the water h ose on intake m anifold from
thenippleonthechaincover.
12. Remove the delivery pipe and intake manifold as an
assembly.
NOTE
Except such cases as defects of injectors or pipe, do
not disassemble a delivery pipe from an intake mani-
fold because it is one of the fuel system parts, or you
may have some problem in fuel system.
13. Install intake manifold and new gasket on the cylinder
head.
Tightening torque
1st : 3.9 ~ 5.9Nm (0.4 ~ 0.6k gf.m, 2.9 ~ 4.3lb- ft)
2nd
Bolt : 26.5 ~ 31.4Nm (2.7 ~ 3.2kgf.m, 19.5 ~ 23.1lb-ft)
Nut : 18.6 ~ 23.5Nm (1.9 ~ 2.4kgf.m, 13.7 ~ 17.4lb-ft)
3rd : Repeat 2nd step twice or move.
To Next Page
Loading...