INTAKE AND EXHAUST SYSTEM EMA -97
NOTE
Be careful of the installation directio n.
a-h:1ststeporder
1 ~ 8 : 2nd step order
7
7
3
2
5
8
4
1
6
h
eb
c
g
daf
SBLM16207L
14. Connect the water hose on intake manifold to the nip-
ple on the chain cover.
15. Install delivery pipe.(Refer to De livery p ipe in FL
Group).
16. Install the surge tank and new gasket on the intake
manifold.
Tightening torque
Long bolt : 9.80 ~ 11.76Nm (1.0 ~ 1.2kgf.m,
7.23 ~ 8.68lb-ft)
Shor t bolt, nut : 18.6 ~ 23.5Nm (1.9 ~
2.4kgf.m, 13.7 ~ 17.4lb-ft)
17. Con
nect heater hose(A) and the brake vaccume
ho
se(B).
A
B
SBLM16017L
18. Connect the fuel hose tube(A).
A
SBLM16015L
19. Connect the wiring over the surge tank.
1) Connect the injection harness connector(A)
2) Connect the camshaft position sensor(CMP) har-
ness connector(B).
3) Connect the ground lines(C).
4) Connect the ignition coil harness connector(D).
5) Connect the condensor connector(E).
6) Connect the variable induction system(VIS) sole-
noid valve connector(G).
7) Connect the oil control valve(OCV) harness con-
nector(F).
D
B
A
E
C
F
SBLM16006L
To Next Page
Loading...