Kidde VS1 - Page 129

Chapter 2: Front panel programming
P/N 3102351-EN • REV 005 • ISS 28DEC18 119
Panel event
Printer
Dialer
NET (1-8) CID
Drill
Yes
None
No n/a
Internal fault
Yes
Acct 1
No 307
IP gateway trouble
Yes
None
Yes n/a
Local AC power (disable)
Yes
None
No n/a
Local AC power (trouble)
Yes
None
No n/a
Net rcvr conf fault
Yes
Acct 1
No 354
Net comm fault (1
-8) (disable) Yes
None
No 500
Net comm fault (1
-8) (trouble) Yes
Acct
1 No 354
Outputs are latched
Yes
None
No n/a
Panel silence
No
None
No 315
Program mode
Yes
Acct 1
No 627
Reset
Yes
Acct 1
No 305
Reset/Silence inhibit
No
None
No n/a
Self test fault
Yes
None
No n/a
Signal silence
Yes
None
No n/a
System ground fault
(disable) Yes
None
No n/a
System ground fault (trouble)
Yes
Acct 1
No 310
System startup
Yes
None
No n/a
System wide AC power (disable)
Yes
None
No n/a
System wide AC power (trouble)
No
Acct 1
No 301
Test fire
No
None
No n/a
Time
No
Acct 1
No 625
Walk test
Yes
Acct 1
No 607
To program panel events:
1. Press the Menu button and choose Program.
2. Choose Advanced Program.
3. Enter a level two password.
4. Choose Panel Events.
5. Select the event to be programmed.
6. Choose Event Notification.
7. Configure the event notification options. See the default settings in the table above. Not all
options shown here are displayed on all systems.