Kidde VS1 - Page 259

Appendix E: Releasing Module
P/N 3102351-EN • REV 005 • ISS 28DEC18 249
• Don’t configure Disable members using the User key for correlation groups with panel
events.
• Install a relay confirmation circuit to indicate when the release and prerelease circuits are
active.
• Don’t power the REL from the panel. You must power the REL using a compatible power
supply. See the GSA-REL Technical Reference Manual (P/N 387515-EN) for a list of
compatible power supplies.
REL fault messages
Table 55 below lists the messages you may see for the REL on the panel’s LCD.
Table 55: REL fault messages
Device
Condition LED LCD message
Monitor (Abort)
Short Monitor Monitor
Open Trouble Trouble
Abort [1]
Expanded message: Monitor Open
Pull (Manual)
Short Alarm Pull station
Manual [1]
Expanded message: Pull station
Open Trouble Trouble
Manual [1]
Expanded message: Pull station open
Supervised
Output
(Prerelease_1)
Short Trouble Trouble
Prerelease_1 [1]
Expanded message: Supervised output short
Open Trouble Trouble
Prerelease_1 [1]
Expanded message: Supervised output open
None
(Prerelease_2)
Short Trouble Trouble
Prerelease_2 [1]
Expanded message: Supervised output short
Open Trouble Trouble
Prerelease_2 [1]
Expanded message: Supervised output open