Version 1.1 © Changsha KILOVIEW Electronics CO.,LTD. All rights reserved
HD Video Encoders · User Manual
In addition to the way of DHCP, the encoder also supports manual IP assignment. To change the IP of the
wired network, click “Configure” button in the Ethernet to enter the interface for configuring the IP.
There are two ways to get the address, one is DHCP, and the other is to manual. To use DHCP to
automatically obtain IP, you must first ensure that the router or switch has enabled the DHCP service.
This method is simple and convenient, but the IP obtained by DHCP changes continuously, and you
cannot directly know what IP address the encoder gets. To use manual, you need to enter a fixed IP to
the encoder, and this IP address is fixed as long as the encoder does not restore the factory settings, this
method is more stable. Therefore, the two methods have their own advantages, and can be selected
accordingly.
After Ethernet is configured correctly, you can see that the connection status is “Internet reachable” and
the Internet connection is the default Ethernet port on the Information Board.
5.3.2 WIFI network (Only G series wireless encoders)
WIFI configuration has two modes, which can realize two functions. "Default WIFI" is used as ordinary
terminal, connect router WIFI signal, use WIFI to transmit video; "WIFI1" is as AP hot spot to be
connected by other devices, default hot spot name is "CAST_AP" and the hot spot password is
"12345678". You can use a mobile phone or laptop to connect to this hot spot to log in and manage the
encoder. After connecting to this hot spot, you can log in to the encoder's web page by typing
"192.168.250.254" in the browser of your mobile phone or laptop. As shown in the figure below, click
“Set as Shared Hot spot” of WIFI 1 to customize the shared hot spot name and shared password. You
can select the WIFI channel and the network card to be shared.
To Next Page
Loading...
Need help?
General
