Kimo KIGAS 310 - Introduction; Description of the Analyser; Overview of the Gas Analyser

1. Introduction
1.1. Description of the analyser
The KIGAZ 310 is a flue gas analyser with two interchangeable sensors (long-life O
2
and CO-H
2
), with an additional possibility of 2 sensors, or an
analyser with three interchangeable sensors (long-life O
2
, CO-H
2
and NO) with an additional possibility of a 4
th
sensor (NO
2
,SO
2
or CH
4
), or an
analyser with 4 sensors (long-life O
2
, CO-H
2
, NO and NO
2
or SO
2
).
Its main features are the following :
• Self-test of the instrument
• CO-H
2
dilution
• Integrated water trap with maximum level alarm
• Colour TFT screen
• Integrated printer
• 2 thermocouple connections
• 2 Go of memory
The gas analyser is supplied in a transport case in ABS or metallic (optional) with a magnetic protective cover, a differential pressure kit, an
interchangeable flue gas probe of 300 mm length with integrated draft and LED, a Li-Ion battery and its charger, the LIGAZ-2 software, a USB cable
and a calibration certificate. A paper roll for the printer and a filter are also provided.
This gas analyser is designed to control parameters of flue gas in exhaust duct of heating units. It can not be used in a
permanently way and/or used as an alarm system.
1.1.1. Overview of the gas analyser
Introduction 7
Over-moulded handle
Flue gas probe
Integrated water trap
Integrated printer
TFT 3.5'' colour screen
Single connector for
flue gas probe
(TcK+gas) and draft
Water trap discharge
LED
Fixing cone
Filter location
LED button