Activates position positive/negative limit signals.
Indicates that an error occurs on the driver, and is in the alarm state.
If the parameter adjusting display mode is featured by the decimal system:
When the units place is flickering, press ▲ to add 1 to the current value; press ▼ to deduct 1 from the
current value. When the tens place is flickering, press ▲ to add 10 to the current value; press ▼ to deduct 10
from the current value. When the hundreds place is flickering, press ▲ to add 100 to the current value; press ▼
to deduct 100 from the current value. When the thousands place is flickering, press ▲ to add 1000 to the current
value; press ▼ to deduct 1000 from the current value.
If the parameter adjusting display mode is featured by the hexadecimal system:
When the units place is flickering, press ▲ to add 1 to the current value; press ▼ to deduct 1 from the
current value. When the tens place is flickering, press ▲ to add 0X10 to the current value; press ▼ to deduct
0X10 from the current value. When the hundreds place is flickering, press ▲ to add 0X100 to the current value;
press ▼ to deduct 0X100 from the current value. When the thousands place is flickering, press ▲ to add 0X1000
to the current value; press ▼ to deduct 0X1000 from the current value.
When adjusting decimal parameters, the display mode is automatically switched to the hexadecimal system
if the data is greater than 9999 or less than -9999. In this case, the 3
rd
decimal point from left to right is
highlighted.
To Next Page
Loading...
