Kinco CD622 - Parameters for Pulse Control Mode

58
Fig. 7-3 Common anode connection (to controllers that support valid low level output)
Note:CD2 driver can support 5-24VDC input,so it needn’t add resistors.
CD driver only support 5VDC input,so it needs to add resistors when using 24VDC input.
4. Common cathode connection (to controllers that support valid high level output)
Fig. 7-4 Common cathode connection (to controllers that support valid high level output)
Note:CD2 driver can support 5-24VDC input,so it needn’t add resistors.
CD driver only support 5VDC input,so it needs to add resistors when using 24VDC input.
7.1.2 Parameters for Pulse Control Mode
1. Parameters for electronic gear ratio
Table 7-1 Parameters for electronic gear ratio
Numeric
Display
Variable Name
Meaning
Default Value
Range
d3.34
Gear_Factor
Numerator of electronic
1000
-32767~32767