Kinco CD622 - Wirings of Digital Input Port

51
Table 6-13 Settings on operation mode control on drivers
Numeric Display
Variable Name
Parameter Settings
d3.03
Din3_Function
Set to 000.4
d3.16
Din_Mode0
Set to 0.004 (-4)
d3.17
Din_Mode1
Set to 0.003 (-3)
d3.00
Store_Loop_Data
Set to 1
Note: If the driver is required to operate in some mode with power on, one of the digital input must be set as
function “Operation Mode Control”. Then you can set the operation modes that require in the parameters
d3.16 or d3.37 in Group F003.
6.1.5 Wirings of Digital Input Port
1. NPN wiring diagram (to the controller that supports low level output)
Fig. 6-2 PNP wiring diagram (to the controller that supports low level output)
2. PNP wiring diagram (to the controller that supports high level output)