Kinco servo does not configure motor in default setting. Customers should configure it when they get a
new servo.
1. Customers have the data file（No need to configure motor）
Use the CD-PC software to download data file to servo driver, then driver and motor can work
normally. Please contact us if there is any problem after downloading. In CD-PC, click the
Extend-->Write Driver Config. Then open the data file (For example, name.cdi), write it to driver.
Note: You should download the new version software from our website: http://www.kinco.cn/en/
Fig.5-1 Data file downloading
2. Customers do not have data file（They need configure motor model in servo）
Note： ■=A: No brake □= H：Direct cable connector √：Recommended
Configuration
=B: With brake =N：HFO series standard connector of Servo and Motor
= C：YL22 series standard connector
= M：2*M17 series Intercontec connector
= D ： M17+M23 (Power M23 Intercontec connector, Encoder M17 Intercontec
connector)
To Next Page
