Accessories
The K-Bubble accessory pack contains the following inflatable tools
Get Started
The sensor is equipped with a USB C port used for charging, 1 LED for the
working/charging state and one push-button.
You can charge your K-Bubble sensor through the USB A to USB C cable provided or with
any USB-C charging cable. The sensor is supplied with the appropriate IEC 60601 medical
USB power supply. If a different charger is used, ensure that it meets the minimum
medical safety requirements and if unsure please do not use the sensor while plugged in /
charging sensor.
Press the orange power on button on K Bubble. The indicator begins
flashing green. Your
sensor is ON! Your sensor will turn off after 10 minutes of no Bluetooth connection or no
application connection.
Put the needle in the valve of your in
flatable tool, then go to the homepage and select
the corresponding in
flatable tool and begin to work following the onscreen instructions.
Important
- Moisten the needle before inserting in the in
flatable accessories to prevent
damage and improve the seal.
- Carefully insert the needle straight into the needle valve of the accessory.
- The needle must
fit tight, without touching the internal opposite side of the
in
flatable accessory
Zeroing of the pressure
The test result comparability is in
fluenced by the pressure inside the inflatable accessory.
After inserting the needle in the valve, unscrew about half a turn the needle from the
socket to allow the pressure to equalize for about 5 sec. Then tighten the needle again.
Please make sure that everything is tight and when squeezing and no air leak is heard or
air bubbles are formed on the valve. Although the sensor is working in absolute terms and
is thus unaffected by the external/internal pressure difference the in
flatable accessory will
behave differently if over- or under- in
flated.
In order to change accessories the above process will have to be repeated.
19 © 2022 KINVENT Biomecanique E2022C_EN
To Next Page
Loading...
