• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Canada
This sensor contains license-exempt transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject
to the following two conditions:
1.This sensor may not cause interference.
2.This sensor must accept any interference, including interference that may cause
undesired operation of the sensor.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme
aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes:
1.L’appareil ne doit pas produire de brouillage.
2.L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
This radio transmitter has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly prohibited for use with
this sensor.
Le présent émetteur radio a été approuvé par Innovation, Sciences et Développement
économique Canada pour fonctionner avec les types d'antennes énumérés ci-dessous et
ayant un gain admissible maximal. Les types d’antenne non inclus dans cette liste, et dont
le gain est supérieur au gain maximal indiqué pour tout type
figurant sur la liste, sont
strictement interdits pour l’exploitation de l’émetteur.
Japan
The Bluetooth module has received type certi
fication, and is labeled with its own
technical conformity mark and certi
fication number, as required, to conform to the
technical standards regulated by the Ministry of Internal Affairs and Communications
(MIC) of Japan pursuant to the Radio Act of Japan.
Certi
ficate number 020-200037, 201-190838/00
Switzerland
For the Swiss market, our product range is registered with swissmedic and our authorised
representative for Switzerland (CH-REP) is Freyr Life Sciences GmbH.
32 © 2022 KINVENT Biomecanique E2022C_EN