Kinvent K-Grip - Installation; On the Floor; Get Started

K- SENSORS User Manual
Installation
Install K Deltas XL according to the measurement programme selected according to the
on -screen instructions.
On the floor
This con
figuration is ideal for balance exercises. You can place K Deltas XL on the ground
either side by side or spaced apart. This increases the dif
ficulty level of balance exercises,
as you can work on your lower limbs muscular force at the same time.
Get started
Each Deltas XL platform is
fitted with a USB C port used for charging, 1 LED for the
working/charging state and one push-button.
You can charge K-Deltas XL sensors through the USB A to USB C cable provided or with
any USB-C charging cable. The sensor is supplied with the appropriate IEC 60601 medical
USB power supply. If a different charger is used, ensure that it meets the minimum
medical safety requirements and if unsure please do not use the sensor while plugged
in/charging
Disinfect K-Deltas XL prior to use, using antiseptic alcohol wipes.
To switch on K-Deltas XL press the on-off button on each platform . You will notice a green
flashing LED. Your K-Deltas XL are on! Your K-Deltas XL will switch off after 10 minutes of
inactivity.
Once the sensor is switched on, go to the homepage, and select K-Deltas sensor and an
activity.
Warning: While your sensor is connecting, do not load the sensor, do not step on the
sensor, do not move the sensor, do not apply force on the sensor.
27 © 2022 KINVENT Biomecanique E2022C_EN