M0276-01Grain Cart
2-8 Rev. 2/18
TM
Operation
UNLOAD GRAIN CART
1. Open roll tarp completely. Refer to
““Manual and Electric Roll Tarp” on page 2-13.
2. Unfold vertical auger.
3. Engage PTO at low tractor RPM.
4. Start to open flow gate and increase tractor RPM. An
indicator on front panel shows position of flow gate.
5. Set grain flow gate and tractor RPM to desired level.
6. Adjust tip spout. Slow tractor RPM as cart reaches empty.
7. Close flow gate.
8. Allow vertical auger to clean out and disengage PTO.
9. Fold auger to storage position.
Flow Gate Position Indicator
Operating tractor PTO above 750
RPM with augers empty will damage
equipment.
Make sure grain is flowing properly
before increasing to higher RPM’s. Read
Operator’s Manual for instructions.
NOTICE
Roll tarp must be completely open during
loading and unloading operations or
suction will damage equipment.
NOTICE
Do not transport cart with vertical auger
extended. This can cause loss of control
and could result in death, serious injury,
or damage to property or equipment.
WARNING
Never work around PTO or gearbox drive
system or allow anyone else to do so
while PTO is running.
DANGER
To Next Page
Loading...
