M0276-01Grain Cart
2-26 Rev. 2/18
TM
Operation
ELECTRONIC SCALE - GT 560 AUTOLOG
The GT 560 indicator has many features but it also boasts simple handsoff operation using a RPM sensor on the PTO
shaft to trigger the start of the unloading process and the end of the unloading process. AutoLog prevents operator
mistakes that could cause you to lose data on loads because the operator “Forgot” to push the “Start/Stop” key.
You can still use “Start/Stop” key before unloading and again after unloading in case the sensor is damaged or not
functioning for any reason. Weight, date, time, and additional information is stored automatically after each load is
completed.
See GT 560 AutoLog Operators Manual provided and Troubleshooting Section of this manual for additional information.
A
Detail A
Hose Clamp
RPM Sensor
To Next Page
Loading...
