TM
Grain Cart
M0276-01
Rev. 2/18 3-3
Lubrication and Maintenance
GREASE FITTINGS
Those parts equipped with grease fittings should be lubricated at the frequency indicated with an SAE multipurpose
grease. Be sure to clean the fitting thoroughly before using grease gun. The frequency of lubrication recommended on
the following pages is based on normal operating conditions. Severe or unusual conditions may require more frequent
attention.
Swivel Hitch (Qty. 1)
NOTE: Disconnect PTO from tractor. Retract PTO assembly and rotate shield to expose grease fitting on PTO
slide.
20 Bolt Hub
Wheel Bearings
(Qty. 1 Per Wheel Hub)
ANNUALLY
7100-277
WEEKLY
7100-110
Extreme operating conditions such as
dirt, temperature or speed may require
more frequent lubrication.
NOTICE
NOTE: Loosen dust cap prior to pumping grease. Tighten after greasing.
To Next Page
Loading...
