M0276-01Grain Cart
3-24 Rev. 2/18
TM
Lubrication and Maintenance
Remove all trash that may be wrapped on shafts and remove dirt that can draw moisture.
Open auger cleanout door and clean out all accumulated grain and debris from auger chamber.
Wash machine inside and out.
After washing machine, leave cleanout door open /" to allow for drainage.
Lubricate machine at all lubrication points.
If possible, remove weight from all tires, particularly if unit is stored outdoors.
Repaint any areas where paint has been removed. This is particularly important in the inside of grain tank. Rust in this
area will shorten cart life and prevent grain from smoothly sliding to bottom of tank.
Inspect machine for parts in need of replacement and order during “off” season.
Coat exposed surface of all cylinder piston rods with grease or rust preventative spray.
Entering the grain cart can result in
death or serious injury.
• Never enter grain cart when there
is an energy source attached to the
cart.
• Flowing grain can trap and suffocate.
DANGER
Contacting rotating auger will cause
death or serious injury. Never open
or close cleanout door with auger
operating.
Remove power source before working on
equipment.
WARNING
Contact with rotating driveline will cause
death or serious injury. Keep away at all
times when operating.
Never operate without all guards and
equipment shields properly installed.
WARNING
PREPARATION FOR STORAGE (CONTINUED)
To Next Page
Loading...
