GENERAL
1-27
S196-WOO Jul. 2003
9.4 EVERY 200 HOURS
A. REPLACING ENGINE OIL FILTER
(1) Engine Oil Filter
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of
the new filter.
3. Tighten the filter quickly until it contacts the mount-
ing surface.
Tighten filter by hand an additional half turn only.
4. After the new filter has been replaced, the engine
oil normally decreases a little. Make sure that the
engine oil does not leak through the seal and be
sure to check the oil level on the dipstick. Then,
replenish the engine oil up to the prescribed level.
B. REPLACING HYERAULIC OIL & TRANSMIS-
SION OIL FILTER (CK20H)
(1) Drain Plugs
1. Remove the drain plug at the bottom of the trans-
mission case and drain the oil completely into the
oil pan.
2. After draining reinstall the drain plug.
196W136A
196W137A
• To prevent serious damage to the engine, use only
a KIOTI genuine filter.
IMPORTANT
To avoid personal injury:
• Be sure to sop the engine before changing oil fil-
ter cartridge.
• Allow engine to cool down sufficiently, oil can be
hot and can burn.
CAUTION
To avoid personal injury:
• Be sure to stop the engine before changing the oil
filter cartridge.
• Allow engine to cool down sufficiently, oil can be
hot and can burn.
CAUTION
To Next Page
Loading...
