13-4 DK55
069OD07A069OD06A
WORKING LIGHT (FRONT/REAR)
(1) Working Light (Front) Switch
(2) Working Light (Rear) Switch
(3) Working Lamp
To turn on, position the switch marked
(front) to “ON” the position.
To turn on, position the switch marked
(rear) to “ON” the position.
WARNING
Do not drive with the working
light (rear) turned on when you
are on the road at night. It is dan-
gerous because it affects the
driver’s view behind you.
In this case, use the hazard lamp.
WIPER
(1) Wiper Operating Switch (Front)
(2) Wiper Operating Switch (Rear)
(3) Wiper Front
1. To turn on, position the switch marked
(wiper) to the “ON” position.
2. When you press the ON direction of
the switch, wash fluid will spray from
the nozzle connected to the wind-
shield wiper.
3. The tank for the washer fluid is
equipped on the left side behind the
seat.
WARNING
You may use general tap water as
the washing fluid. But it is better
to use the washer fluid for auto-
mobile if possible. You have to
use it especially in winter.
If you operate the windshield
wiper without the washer fluid, it
will damage the motor. Therefore,
you should check the washing
fluid before operation.
Do not wash the windshield with
the wiper if it is covered by mud.
Please spray the washing fluid
during the operation of the wiper.
And if you operate the wiper with
the window frozen in winter, the
internal fuse will may short
circuit. Please operate the wiper
after raising the temperature in
this case.
To Next Page
Loading...
