KIP 7000 - Specifications

Part 1 Basic Functions 1-6
1. 4 Specifications
Subject Specification
Model KIP 7000
Configuration Console
Printing method Electrophotography
Photoconductor Organic Photoconductive Drum
Print speed 160mm per second (7 sheets of A0 in one minute)
Print head LED
Resolution 600dpi
Print width Maximum width 914mm (36 inches)
Minimum width 210mm
(
cut sheet
)
/
11inches
(
Roll Paper
)
Print length Maximum length 6000mm or “5 x Standard length”
(Standard)
24000mm or unlimited (Optional)
Minimum length 210mm
NOTE : If the print is longer than 6m, we do not guarantee image
quality or the reliability of media feeding systems.
Warm up time Less than 6 minutes
(At 23 degrees Centigrade, 60% RH and the rated voltage
/Plain Paper)
First print time 15.5 seconds (A0 print from Roll 1)
Fusing method Roll Fuser
Development method Dry type with non-magnetic mono-component toner
Exposure method LED
Charging method Corona
Transfer method Corona
Separation method Corona
Input power 220V - 240V plus 6% or minus 10%, 50/60Hz, 16A
Average power
consumption
230V, 50/60Hz and Dehumidify Heater is ON
Stand by 1.0kwh
Printing 2.6kwh
Acoustic noise Less than 67db (Printing)
Less than 55db (Stand by)
Ozone Smaller than 0.1ppm (Average)
Dimensions 1385mm (Width) x 810mm (Depth) x 1590mm (Height)
(without Tray)
Weight Approx. 370kg
Media (Recommended Media)
Plain Paper US Bond (PB-20)
Tracing Paper US Vellum (XV-20)
Film 4MIL (XPD-4X) (OMM4X)
Environmental condition
for usage
(Temperature)
10 to 32 degrees Centigrade
(Humidity)
15 to 85% RH
Interface Hi-Speed (LVDS) I/F VIII interface
NOTE 1: The above specifications may change without notice.
NOTE 2: <Storage condition of consumables>
Media Wrap the media surely to shut out the humidity.
Toner Keep the toner cartridge away from the direct sunlight, and store it
in the condition of 0 to 35 degrees Centigrade and 10 to 85% RH.